• Home
  • Tormach Workshop #3

Tormach Workshop #3

  • Thu, July 18, 2019
  • Sat, August 03, 2019
  • 3 sessions
  • Thu, July 18, 2019, 6:00 PM 9:00 PM (EDT)
  • Thu, July 25, 2019, 6:00 PM 9:00 PM (EDT)
  • Sat, August 03, 2019, 1:00 PM 5:00 PM (EDT)
  • make717 Inovation Center
  • 2


This is the third of four workshops required in order to use the Tormach. The cost of each workshop is $100 and must be paid at time of registration. All four workshops should be completed within an approximate 6 month time frame. 

Please make sure you are available for all the sessions listed for Workshop 3 prior to registering. Class size is limited to 2 persons.

Workshop 2 must be completed prior to registration. There are also Fusion 360 tutorials and the enclosure CAM that should be done prior to the first session. Depending on your experience level, these items may take a few evenings or more. 

After completing this workshop you will keep the enclosure and will receive all the parts required to assemble it (you will not receive an arduino board). You will also receive a new end mill that can be used after all four workshops are completed.

Primetime hours for maker members
Mon - Fri: 5pm to 9pm
Saturday: 10am to 9pm
Sunday: 10am to 5pm

Copyright 2017 make717, Inc. All Rights Reserved 
Mailing Address:  1653 Lititz Pike #1213, Lancaster, PA 17601
Makerspace Address:  1151 Clark Street, Lancaster, PA 17602
(717) 537-1067 info@make717.org

Powered by Wild Apricot Membership Software