• Home
  • Equipment Orientation: Laser Cutter (Registration Required)

Equipment Orientation: Laser Cutter (Registration Required)

  • Thu, October 10, 2024
  • 6:00 PM - 8:00 PM
  • make717 Innovation Center
  • 4

Registration


Register

Overview

Learn to operate our Full Spectrum laser cutter. The primary focus of the class is to teach safe operation. To attend this course you must be a member.  Not a member yet?  Visit to the Get Started section of our website.

To register, watch the 9 minute video and complete a 7 question quiz. You will then receive an email with the code to register.

Step 1: Watch the Orientation Video

Step 2: Take the Safety Quiz

You must have completed an Information Session and Tour event and have an active membership (either monthly Maker member with your own door access card or Social Maker utilizing the library STEMPass) in order to take the quiz.

Proceed to the laser safety quiz here.

Step 3: After passing the quiz check your email for the registration code

An e-mail will be sent confirming you passed the quiz and will have a code that will allow you to register.

Step 4: Register for the class!

After registration you'll receive further instructions to prepare you for the class. Class size is strictly limited, please no walk-ins. If you'd like to attend the class with family or a friend email the instructor.

This session will be taught by Ryan "DJ" Conley.

Primetime hours for maker members
Mon - Fri: 5pm to 9pm
Saturday: 10am to 9pm
Sunday: 10am to 5pm


Copyright 2017 make717, Inc. All Rights Reserved 
Mailing Address:  1653 Lititz Pike #1213, Lancaster, PA 17601
Makerspace Address:  1151 Clark Street, Lancaster, PA 17602
(717) 537-1067 info@make717.org

Powered by Wild Apricot Membership Software